As a typical counter flow evaporative condenser, KEN evaporative condenser offered excellent heat transfer ability. Compact structure design and lower power, make it easier for the confined space shipment and installation. KEN evaporative condenser can be used in all outdoor applications, especially in high temperature fluid process and dirty environment. And the unit can also operate in dry mode without water during low load and cold weather.
KEF evaporative condenser is a combined flow evaporative condenser and the PVC fill can cool the industrial process fluid effectively. A special coil design is utilized to reduce the air pressure drop through the unit while maximizing tube surface area and increasing its heat transfer capabilities.
The downstream cooling tower uses the latent heat of vaporization to remove heat from the coil by spray water, and then the top fan removes the heat in the spray water for discharge. The air inlet is from the top, alternating with the falling spray water, so it is called a downstream tower.
KEH evaporative condenser is a horizontal flow type evaporative condenser with PVC fill above the heat exchange coil. It is suitable for large industrial refrigeration projects. In the process of circulation, the spray water reduces the water temperature through the PVC heat sink (filler), forming a feng shui flow in the same direction with the fresh incoming air. The coil mainly relies on the spray water for heat exchange. The lower the spray water, the better the cooling effect. An important feature of such an operating principle is the maximum possible suppression of the coil volume. Thus, reducing costs.
The refrigerant gas is discharged from the compressor into the inlet connection of the evaporative condenser. Water from the condenser’s sump is continuously flooded over the condenser coil, while ambient air is simultaneously forced into the unit. As the ambient air moves up through the coil section, a portion of the spray water is evaporated into the air stream.
KEJ evaporative condenser is a hybrid type condenser with fin tube unit. It is designed for the water saving and plume abatement. And It can also reduce the evaporation to minimize the tendency of furring on the coil and following problems. It can operate under dry model while low load.
